Pinion Finishing Summary
FORMATE SPIRAL BEVEL · Generated Pinion (Duplex Helical) · — · —
| PARAMETER | English (in) | Metric (mm) |
|---|---|---|
| Summary Number | — | |
| Customer | — | |
| Number of Teeth (Pinion / Gear) | — / — | |
| Diametral Pitch / Module | — DP | — mod |
| Mean Normal Diametral Pitch | — | |
Face Width | in | mm |
| Pressure Angle — Concave / Convex | 20° 0' / 20° 0' | |
| Shaft Angle | 90° 0' | |
Outer Cone Distance (Ao) | in | mm |
Addendum (a_op / a_og) | in | mm |
Dedendum (b_op / b_og) | in | mm |
Working Depth (h_k) | in | mm |
Whole Depth (h_t) | in | mm |
Outside Diameter (Pinion) | in | mm |
Pitch Apex to Crown (Pinion) | in | mm |
Pitch Angle (Pinion γ_p) | —(—°) | |
Face Angle of Blank (Pinion) | —(—°) | |
Root Angle (Pinion) | —(—°) | |
Dedendum Angle (Pinion δ_p) | —(—°) | |
Spiral Angle (β_m) | —(—°) | |
Hand of Spiral | LH (Pinion) / RH (Gear) | |
Cutting Method | DUPLEX (Pinion) · NON-GENERATED / FORMATE (Gear) | |
Backlash | — | |
Driving Member | P | |
Direction of Rotation (Driver) | CW | |
| PARAMETER | English (in) | Metric (mm) |
|---|---|---|
| PARAMETER | O.B. (Outside Blade) | I.B. (Inside Blade) |
Profile Radius of Curvature (in / mm) | O.B.in / mm | I.B.in / mm |
Point Radius (in / mm) | O.B.in / mm | I.B.in / mm |
Profile Center Axial Distance Y (in / mm) | O.B.in / mm | I.B.in / mm |
Profile Center Radial Distance X (in / mm) | O.B.in / mm | I.B.in / mm |
Blade Dedendum (in / mm) | O.B.in / mm | I.B.in / mm |
Tip Blade Angle (°) | O.B.in / mm | I.B.in / mm |
| PARAMETER | English (in) | Metric (mm) |
|---|---|---|
| Contact Balance Factor | ||
| Bias Factor | Drive | Coast |
| Profile Separation Factor | Drive | Coast |
| Contact Position Factor | Drive | Coast |
| Offset (E/V) | Drive | Coast |
| Pin Cone (P/H) | Drive | Coast |
Enter cutter dimensions and control data above, then press Calculate Pinion Summary.